3DKin Menus
Listed below are the various menus for the
Kinetics program. Select the desired menu to see a description of the available commands
for each menu.
FILE MENU COMMANDS
Save project
Use this menu item to save the current calculation setup.
Open project
Click this menu item to load a previously stored calculation setup. This
can be very usefull if the same setup has been used for more than one person. After
changing a few parameters the setup/project can be saved and stored using a new name.
Exit
Selected to EXIT the 3DKin module.
Preferences MENU COMMANDS
Output parameters
View the output parameters. This dialog is used to setup the output from
the actual calculation. Meaning what parameters needs to be stored on disk and what
parameters that is not to important.
Joint center parameters
View and adjust the joint center parameters used in the calculation of the
kinetics and kinematics data.
Forceplate setup
View and adjust the forceplate parameters used in the calculation of the kinetics
and kinematics data.
Calibration frame setup
View and adjust the calibration cube parameter used in the calculation of
the kinetics and kinematics data.
HELP MENU COMMANDS
About 3DKin
Provides information about the 3DKin program.